Skip to content
Appliance RepairRockford, Illinois

Oven Repair in Rockford, IL

Updated

Short answer

Oven repairs average $200, mostly $130 to $310 (Angi, 2026). On an electric oven, Whirlpool says a bake element that does not glow red is a sign it needs replacing; on a gas oven, a dirty or failed igniter is the usual suspect. An F code is the control reporting a fault: GE's F2 means the oven passed a preset temperature, and Frigidaire's F10 is a thermal runaway.
Call (815) 800-0677All 2026 repair prices
Gloved hand holding a new bake element in front of an open electric oven

Not heating

Whirlpool's list for an oven that will not heat (Whirlpool):

  • The bake element should glow red when heating; if it does not, it may need replacing.
  • The door seal has to hold the heat in, and the door has to close fully.
  • The temperature sensor sits at a 90 degree angle; if it is out of place or an element is too close to it, readings go wrong.
  • On gas ovens, a dirty or faulty igniter can stop the oven from heating.

F codes

GE's own table: F2 or F20 means the oven temperature exceeded a preset threshold; F3 and F4 usually mean the oven sensor needs replacing; F0, F1, F6 and F7 usually point at the keypanel; F5 and F8 at the electronic control; F9 at the door lock circuit (GE Appliances). Frigidaire: F10 thermal runaway, F30 open probe, F31 shorted probe, F90 to F94 door lock (Frigidaire). Full lists in the GE and Frigidaire guides.

What the repair usually is

  • Thermostat or door switch: about $150
  • Igniter: about $200
  • Control board: $150 to $300 (about $225 average)
  • Heating element: about $275
  • Clicking gas oven: $200 to $350
  • Door repair or replacement: $100 to $400

Angi puts electric oven repairs at $100 to $250 and gas or convection ovens at $100 to $600 (Angi).

Gas and carbon monoxide

Anything on the gas side of a range is for a qualified technician. If you smell gas, leave and call Nicor Gas at 888-642-6748 and 911 from outside (Nicor Gas), and keep a working CO alarm within 15 feet of bedrooms as Illinois requires (430 ILCS 135/10).

Sources: Angi, oven repair cost (updated Sep 11, 2026); Whirlpool, why is my oven not heating up; GE Appliances, oven error, fault or function codes; Frigidaire, ranges error code guide; Frigidaire, oven error codes and alarms guide; Nicor Gas, Emergency Information; 430 ILCS 135/10, Carbon Monoxide Alarm Detector Act

Common questions

Oven Repair: questions

Why is my electric oven not heating?

Whirlpool's first suspects: a bake element that no longer glows red, a door that does not seal, or a temperature sensor knocked out of position.

What does F2 mean on a GE oven?

GE says F2 or F20 means the oven temperature has exceeded a preset threshold. Turn the oven off and let it cool; a repeat code needs service.

How much does oven repair cost?

Angi's 2026 guide averages $200, with most repairs $130 to $310. An igniter is about $200 and a control board about $225.

What is a Frigidaire F10 code?

Frigidaire calls F10 thermal runaway: the oven is detecting higher-than-normal temperatures. Turn it off and let it cool; if it persists, contact service.

Related guides

Other appliances

Refrigerator RepairNot cooling, too warm, frost buildup, leaks, noisy fans, failed control boards and sealed-system work.Freezer RepairChest and upright freezers that stop freezing, frost over, run constantly or trip a breaker.Ice Maker RepairRefrigerator and freestanding ice makers that make no ice, small cubes, or leak. Hard water is a common cause here.Washer RepairFront-load and top-load washers that will not drain, fill, spin or unlock, leak, or show an error code.Dryer RepairGas and electric dryers that will not heat, tumble or start, take two cycles to dry, or shut off early.Gas Dryer RepairNatural gas and propane dryers: igniters, gas valves, LP conversions and the burner side of no-heat calls.Dishwasher RepairDishwashers that will not drain, fill, clean or dry, leak, leave white film, or show an error code.Gas Range RepairGas stoves with burners that click but will not light, weak or yellow flames, and igniter or valve faults.

Oven trouble?

Tell us the appliance, the brand, the model number if you have it, and what it is doing. A local technician calls back with a time and a price before any work starts.

Call (815) 800-0677See 2026 Prices